Goniometer
Measures the angle between two arms on the bench and labels it, with Markdown and LaTeX in the label.
Open in the canvas →In the real world
Figures of optical setups state the angles that matter: the fold angle at a mirror, the angle of incidence on a prism or a grating, the crossing angle of two beams in a crystal. Two lines from a vertex with an arc between them, and the angle written beside it, say it on the figure itself.
In OpticalSetup
Select the goniometer: it has a round handle at its vertex and one at the tip of each arm. Dragging an arm's tip turns only that arm about the vertex, smoothly and without the grid, keeping its length, which the inspector sets; the other arm stays where it is. The purple knob tunes the angle by itself, dragging up to open it, and the vertex handle moves the whole goniometer. Shift steps the angle by 5°.
With auto clamp, on by default, the vertex clicks into place near what a measurement usually starts from: a component's centre or its optically active point (a laser's aperture, an objective's tip), another ruler's or goniometer's handle, a bend in a beam such as its fold at a mirror, or a beam's axis; away from these it falls back to the grid when Snap is on. The beam axis is the central ray of each traced beam, a ray drawn on its own (a laser drawn as a line, each ray of an object's fan), or an arrow drawn as a beam; a point source has no single axis, so only its centre is a target. An arm clicks onto a beam whose axis runs through the vertex, or turns toward a component, and a dashed purple line shows what it has clicked onto. Hold Alt to place or turn freely.
The label is Markdown, as in a text label, with LaTeX formulas between dollar signs, and {value} in it is replaced by the measurement with the chosen number of decimal places. Inside a formula the unit is set upright, and a label without {value} shows no number at all.
The angle between the arms runs from 0 to 180°; the sign of the stored value only says which way the second arm opens. $\theta = {value}$ reads θ = 90°. The label stays level, out along the bisector. For a distance, use the ruler.
The example reads the fold angle at a mirror, with the arms along the incoming and the reflected beam.
The goniometer measures the drawing: the angle between its two arms. It does not attach to a component or follow a beam: an arm laid along a beam stays where it was put when the beam moves. The goniometer is diagram-only and never absorbs or redirects rays.